1.1 --- a/cartridge.scad Sun Apr 10 17:45:23 2016 +0200
1.2 +++ b/cartridge.scad Sun Apr 10 19:02:37 2016 +0200
1.3 @@ -765,22 +765,19 @@
1.4 -1, -1, 1,
1.5 int_payload_left_extent, 0, int_payload_lower_extent);
1.6
1.7 - if (BACK_CONNECTOR_SECTION) {
1.8 -
1.9 - /* Cutout to accept the back connector sides. */
1.10 + /* Cutout to accept the back connector sides (or the floor of the back piece). */
1.11
1.12 - cube_at(inner_connector_front_cutout_width,
1.13 - inner_connector_front_cutout_depth,
1.14 - inner_connector_front_cutout_height,
1.15 - 1, -1, -1,
1.16 - int_connector_width / 2, 0, int_payload_lower_extent);
1.17 + cube_at(inner_connector_front_cutout_width,
1.18 + inner_connector_front_cutout_depth,
1.19 + BACK_CONNECTOR_SECTION ? inner_connector_front_cutout_height : bottom,
1.20 + 1, -1, -1,
1.21 + int_connector_width / 2, 0, int_payload_lower_extent);
1.22
1.23 - cube_at(inner_connector_front_cutout_width,
1.24 - inner_connector_front_cutout_depth,
1.25 - inner_connector_front_cutout_height,
1.26 - -1, -1, -1,
1.27 - -int_connector_width / 2, 0, int_payload_lower_extent);
1.28 - }
1.29 + cube_at(inner_connector_front_cutout_width,
1.30 + inner_connector_front_cutout_depth,
1.31 + BACK_CONNECTOR_SECTION ? inner_connector_front_cutout_height : bottom,
1.32 + -1, -1, -1,
1.33 + -int_connector_width / 2, 0, int_payload_lower_extent);
1.34
1.35 /* Fillets to round off the edges. */
1.36